Saturday, May 20, 2017

Small servers for database performance tests

I use Intel NUC servers at home to test open source databases. I like them because they are small, quiet and don't use much power. For about 2 years I have been using NUC5i3ryh servers with a 5th gen core i3 CPU, 8gb of RAM, 2.5" SATA disk for the OS and 120gb Samsung 850 EVO m.2 for the database. I used this so much that I replaced the SSD devices last year after one reached the endurance limit.

I am upgrading to a new setup using NUC7i5bnh. This has a 7th gen core i5, 16gb of RAM, 2.5" SATA SSD (Samsung 850 EVO) for the OS and m.2 SSD (Samsung 960 EVO) for the database. It has twice the RAM, twice the CPU and more than twice the IOPs of my old setup. The old and new setups use Ubuntu 16.04 server.

The install was easy with one exception. The old setup used wired networking. This time I enabled wireless after the install finished and that took a few hours to figure out. The important steps are:
  1. Install the HWE enabled kernel to get the drivers that support Intel wireless HW in this server. I didn't do this at first and dmesg | grep iwl showed nothing even though the firmware for that Intel HW was installed. With the HWE kernel I see this in dmesg output Detected Intel(R) Dual Band Wireless AC 8265. The HWE kernel can be selected at the GRUB menu during the install. I assume this step won't be needed once the NUC7i5bnh HW becomes less new.
  2. After the install finishes, install wireless-tools via sudo apt-get install wireless-tools. Without this ifup -v wlan0 failed.
  3. Edit /etc/network/interfaces. This assumes you are using an unsecured network. See below.
I changed /etc/network/interfaces to enable wireless and disable wired using the following contents. After editing the file I tested my changes via sudo ifup -v wlp58s0. If you get it wrong this will take a few minutes to fail. Note that $name is the name for your wireless network and that this works when you are running an unprotected 
# The loopback network interface
auto lo
iface lo inet loopback 
# Wired networking is not started automatically
auto eno1
iface eno1 inet manual
#iface eno1 inet dhcp 
# Wireless networking is started automatically
auto wlp58s0
iface wlp58s0 inet dhcp
wireless-essid $name
wireless-mode Managed
First performance comparison is "make -j4" for MySQL 8.0.1 - 1307 seconds for old NUC, 684 seconds for new NUC.

1 comment:

  1. Intel NUCs are a real joy to use, have 2 of them running 24 hour test runs of our test suite for my own development tasks whenever I need to which is quite often. Only time I hear them is when it compiles MySQL, running the test suite it spins along nicely and produces nice results. Have a feeling I will also exhaust the SSDs eventually, but so far so good. One of them is even equipped with 2 SSDs. Had some issues installing Linux Mint on them, but some Googling solved that eventually.